JAJSF71A April 2018 – May 2017 TLIN1024-Q1
The TLIN1024-Q1 device is a Quad Local Interconnect Network (LIN) physical layer transceiver, compliant to LIN 2.0, LIN 2.1, LIN 2.2, LIN 2.2A and ISO/DIS 17987–4.2, with integrated wake-up and protection features. The TLIN1024-Q1 has two separate dual LIN transceiver blocks. VSUP1/2 provides power to the separate dual transceiver blocks. The LIN bus is a single wire bidirectional bus typically used for low speed in vehicle networks using data rates up to 20 kbps. The TLIN1024-Q1 LIN receivers work up to 100 kbps supporting in-line programming. The LIN protocol output data stream on the TXD in converted by the TLIN1024-Q1 into LIN bus signal using a current-limited wave shaping driver as outlined by the LIN physical layer specification. The receiver converts the data stream to logic level signals that are sent to the microprocessor through the open drain RXD pin. The LIN bus has two states: dominant state (voltage near ground) and recessive state (voltage near battery). In the recessive state, the LIN bus is pulled high by the internal pull-up resistor (45 kΩ) and a series diode. No external pull-up components are required for slave applications. Master applications require an external pull-up resistor (1 kΩ) plus a series diode per the LIN specification. The TLIN1024-Q1provides many protection features such as ESD, EMC and high bus standoff voltage.
The TLIN1024-Q1 support wide operating ranges with VSUP1/2 of 4 V to 36 V, ±42 V LIN bus fault protection, -40 to +125 C TA. Sleep mode is supported which is Ultra-Low current consumption. There are two methods of to wake up the TLIN1024-Q1 from sleep mode; by the LIN bus and local wake-up using the EN pin. There are many protection features provided by the TLIN1024-Q1 such as HBM ESD protection exceeds ±8 kV and IEC ESD protection exceeds ±8 kV on LIN pins, under voltage protection on VSUP1/2, TXD Dominant Time Out Protection (DTO), thermal shutdown protection and unpowered node or ground disconnection failsafe at system level. VSUP1 and GND1 supplies transceivers 1 and 2 while VSUP2 and GND2 supplies transceiver 3 and 4. The TLIN1024-Q1 is part of the LIN family that includes the TLIN1022 and TLIN1029 LIN transceivers.