SLVS822E March 2009 – September 2015
PRODUCTION DATA.
PIN | I/O | DESCRIPTION | |
---|---|---|---|
NAME | NO. | ||
EN | 5 | I | Enable pin. Driving the EN pin high turns on the regulator over full operating range. Driving this pin low puts the regulator into shutdown mode over full operating range. |
IN | 8 | I | Input pin. TI recommends a 0.1-μF ceramic or greater capacitor from this pin to ground to assure stability. Both input and output capacitor grounds should be tied back to the IC ground with no significant impedance between them. |
GND | 4 | O | Ground. The exposed thermal pad is connected to ground through this pin. |
OUT | 1 | O | Regulated output voltage pin. A small (1 μF) capacitor is needed from this pin to ground to assure stability. |
SENSE/FB | 2 | I | This pin is the input to the control loop error amplifier; it is used to set the output voltage of the device. |
NC | 3, 6, 7 | — | No internal connection |