SBVS343 March   2019 TPS7A78

ADVANCE INFORMATION for pre-production products; subject to change without notice.  

  1. Features
  2. Applications
    1.     Typical Schematic
  3. Description
  4. Revision History
  5. Pin Configuration and Functions
    1.     Pin Functions
  6. Specifications
    1. 6.1 Absolute Maximum Ratings
    2. 6.2 ESD Ratings
    3. 6.3 Recommended Operating Conditions
    4. 6.4 Thermal Information
    5. 6.5 Electrical Characteristics
    6. 6.6 Timing Requirements
    7. 6.7 Typical Characteristics
  7. Detailed Description
    1. 7.1 Overview
    2. 7.2 Functional Block Diagram
    3. 7.3 Feature Description
      1. 7.3.1 Active Bridge Control
      2. 7.3.2 Full Bridge (FB) and Half Bridge Configurations
      3. 7.3.3 4 to 1 Switch Capacitor Voltage Reduction
      4. 7.3.4 VLDO_IN Overvoltage Protection
      5. 7.3.5 Dropout Voltage Regulation
      6. 7.3.6 Current Limit
      7. 7.3.7 Programmable Power-Fail Detection
      8. 7.3.8 Power-Good (PG) Detection
      9. 7.3.9 Thermal Shutdown
    4. 7.4 Device Functional Modes
      1. 7.4.1 Normal Operation: AC Input mode
      2. 7.4.2 Dropout Mode
      3. 7.4.3 Disabled Mode
      4. 7.4.4 Normal Operation: DC Input mode
  8. Application and Implementation
    1. 8.1 Application Information
      1. 8.1.1 Recommended Capacitor Types
      2. 8.1.2 Cap-Drop Capacitor CS
      3. 8.1.3 Surge Resistor RS
      4. 8.1.4 Input and Output Capacitors Requirements
    2. 8.2 Typical Application
      1. 8.2.1 Design Requirements
      2. 8.2.2 Detailed Design Procedure
      3. 8.2.3 Application Curves
  9. Power Supply Recommendations
  10. 10Layout
    1. 10.1 Layout Guidelines
    2. 10.2 Layout Example
  11. 11Device and Documentation Support
    1. 11.1 Receiving Notification of Documentation Updates
    2. 11.2 Community Resources
    3. 11.3 Trademarks
    4. 11.4 Electrostatic Discharge Caution
    5. 11.5 Glossary
  12. 12Mechanical, Packaging, and Orderable Information

パッケージ・オプション

メカニカル・データ(パッケージ|ピン)
発注情報

Typical Application

This section discusses implementing this device for a typical application. Figure 10 shows an optimized e-meter application using a HB configuration and depending on the implementation either Line or Neutral can be referenced to device GND to share the same GND as the MCU monitoring the environment. In this design Neutral is referenced to device GND pin.

TPS7A78 tps7a78-1phase.gifFigure 10. TPS7A78 For Single-Phase E-Meters