4 改訂履歴
Changes from C Revision (August 2016) to D Revision
- Changed Bus free time between start and stop specifications minimum from "4.7 μs" to "1.3 μs" in I2C/Smbus/PMBus Timing Requirements section Go
- Changed Hold time after (repeated) start, Repeated-start setup time, Stop setup time, and Clock high period specifications minimum from "0.26 μs" to "0.6 μs" in I2C/Smbus/PMBus Timing Requirements sectionGo
- Changed Data setup time specification minimum from "50 ns" to "100 ns" in I2C/Smbus/PMBus Timing Requirements sectionGo
- Changed Clock low period specification minimum from "0.5 μs" to "1.3 μs" in I2C/Smbus/PMBus Timing Requirements sectionGo
- Changed Clock/data fall time specification maximum from "120 ns" to "300 ns" in I2C/Smbus/PMBus Timing Requirements sectionGo
- Added Total capacitance of one bus line specification to I2C/Smbus/PMBus Timing Requirements sectionGo
- Clarified instructions in Programming section Go
- Updated Table 10Go
- Clarified Full Configuration Update While in Normal Mode sectionGo
- Added steps 6 through 9 in Design Requirements sectionGo
Changes from B Revision (December 2015) to C Revision
Changes from A Revision (August 2011) to B Revision
- Added 「ピン構成および機能 」セクション、「ESD 定格」表、「機能説明」セクション、「デバイスの機能モード」セクション、「アプリケーションと実装」セクション、「電源に関する推奨事項」セクション、「レイアウト」セクション、「デバイスおよびドキュメントのサポート」セクション、「メカニカル、パッケージ、および注文情報」セクションGo
- Changed minimum storage temperature from –40 to –55Go
- Changed the Functional Block DiagramGo
- Deleted the second paragraph under Monitoring sectionGo
- Updated Voltage Monitoring section.Go
- Updated pin numbers in GPIO Pin Configuration Options table.Go
- Updated first item in the GPI Special Functions section.Go
- Updated last sentence in Power-Supply Enables section.Go
- Updated JTAG INTERFACE section.Go
- Updated Programming section.Go