ホーム パワー・マネージメント AC/DC と絶縁型 DC/DC の各スイッチング・レギュレータ PWM コントローラ

MOSFET ドライバ内蔵、フルブリッジ PWM コントローラ

製品詳細

Topology Full bridge, Half bridge, Push pull Control mode Current Duty cycle (max) (%) 50 Switching frequency (max) (kHz) 2000 Features Current limiting, High-voltage startup, Integrated gate drivers, Multi-topology, SR logic, Synchronization pin UVLO thresholds on/off (V) Programmable/1.25V Operating temperature range (°C) -40 to 125 Rating Catalog Gate drive (typ) (A) 1.5, 2 Vin (max) (V) 14
Topology Full bridge, Half bridge, Push pull Control mode Current Duty cycle (max) (%) 50 Switching frequency (max) (kHz) 2000 Features Current limiting, High-voltage startup, Integrated gate drivers, Multi-topology, SR logic, Synchronization pin UVLO thresholds on/off (V) Programmable/1.25V Operating temperature range (°C) -40 to 125 Rating Catalog Gate drive (typ) (A) 1.5, 2 Vin (max) (V) 14
HTSSOP (PWP) 28 62.08 mm² 9.7 x 6.4 WQFN (RSG) 28 25 mm² 5 x 5
  • Highest Integration Controller for Small Form
    Factor, High-Density Power Converters
  • High-Voltage Start-Up Regulator
  • Intelligent Sync Rectifier Start-Up Allows Linear
    Turnon Into Prebiased Loads
  • Synchronous Rectifiers Disabled in UVLO mode and
    Hiccup Mode
  • Two Independent, Programmable Synchronous Rectifier
    Dead-Time Adjustments
  • Four High-Current 2-A Bridge Gate Drivers
  • Wide-Bandwidth Optocoupler Interface
  • Configurable for Either Current Mode or Voltage
    Mode Control
  • Dual-Mode Overcurrent Protection
  • Resistor Programmed 2-MHz Oscillator
  • Programmable Line UVLO and OVP
  • Highest Integration Controller for Small Form
    Factor, High-Density Power Converters
  • High-Voltage Start-Up Regulator
  • Intelligent Sync Rectifier Start-Up Allows Linear
    Turnon Into Prebiased Loads
  • Synchronous Rectifiers Disabled in UVLO mode and
    Hiccup Mode
  • Two Independent, Programmable Synchronous Rectifier
    Dead-Time Adjustments
  • Four High-Current 2-A Bridge Gate Drivers
  • Wide-Bandwidth Optocoupler Interface
  • Configurable for Either Current Mode or Voltage
    Mode Control
  • Dual-Mode Overcurrent Protection
  • Resistor Programmed 2-MHz Oscillator
  • Programmable Line UVLO and OVP

The LM5045 PWM controller contains all of the features necessary to implement full-bridge topology power converters using either current mode or voltage mode control. This device is intended to operate on the primary side of an isolated DC-DC converter with input voltage up to 100 V. This highly integrated controller-driver provides dual 2-A high-side and low-side gate drivers for the four external bridge MOSFETs plus control signals for the secondary-side synchronous rectifier MOSFETs. External resistors program the leading and trailing edge dead-time between the main and synchronous rectifier control signals. Intelligent start-up of the synchronous rectifiers allows monotonic turnon of the power converter even with prebias load conditions. Additional features include cycle-by-cycle current limiting, hiccup mode restart, programmable soft-start, synchronous rectifier soft-start, and a 2-MHz capable oscillator with synchronization capability and thermal shutdown.

The LM5045 PWM controller contains all of the features necessary to implement full-bridge topology power converters using either current mode or voltage mode control. This device is intended to operate on the primary side of an isolated DC-DC converter with input voltage up to 100 V. This highly integrated controller-driver provides dual 2-A high-side and low-side gate drivers for the four external bridge MOSFETs plus control signals for the secondary-side synchronous rectifier MOSFETs. External resistors program the leading and trailing edge dead-time between the main and synchronous rectifier control signals. Intelligent start-up of the synchronous rectifiers allows monotonic turnon of the power converter even with prebias load conditions. Additional features include cycle-by-cycle current limiting, hiccup mode restart, programmable soft-start, synchronous rectifier soft-start, and a 2-MHz capable oscillator with synchronization capability and thermal shutdown.

ダウンロード 字幕付きのビデオを表示 ビデオ

技術資料

star =TI が選定したこの製品の主要ドキュメント
結果が見つかりませんでした。検索条件をクリアしてから、再度検索を試してください。
5 をすべて表示
種類 タイトル 最新の英語版をダウンロード 日付
* データシート LM5045 Full-Bridge PWM Controller With Integrated MOSFET Drivers データシート (Rev. H) PDF | HTML 2015年 1月 28日
セレクション・ガイド 電源 IC セレクション・ガイド 2018 (Rev. R 翻訳版) 英語版 (Rev.R) 2018年 9月 13日
ユーザー・ガイド AN-2111 LM5045 Evaluation Board (Rev. C) 2013年 5月 6日
アプリケーション・ノート AN-2213 LM5045 Based 240W Power Converter Using Full-Wave (Rev. A) 2013年 5月 6日
アプリケーション・ノート Applying I2C-Compatible Temperature Sensors in Systems With Slow Clock Edges (Rev. A) 2013年 5月 6日

設計と開発

その他のアイテムや必要なリソースを参照するには、以下のタイトルをクリックして詳細ページをご覧ください。

評価ボード

LM5045EVAL — LM5045 評価ボード

The LM5045 evaluation board is designed to provide the design engineer with a fully functional power converter based on the full-bridge topology to evaluate the LM5045 PWM controller. The evaluation board is provided in an industry standard quarter brick footprint.
シミュレーション・モデル

LM5045 PSPICE Model

SNVM006.ZIP (350 KB) - PSpice Model
計算ツール

SLUC501 LM5045 Design Calculator

サポート対象の製品とハードウェア

サポート対象の製品とハードウェア

製品
PWM コントローラ
LM5045 MOSFET ドライバ内蔵、フルブリッジ PWM コントローラ
リファレンス・デザイン

PMP31092 — 低プロファイル、140W フルブリッジのリファレンス・デザイン

この電源は、高密度と部品の高さ低減を必要とするアプリケーションに適した、平面トランスを採用した 140W フルブリッジのリファレンス・デザインです。このデザインは、2 次側でショットキー・ダイオードを使用し、LM5045 を使用して駆動するハード・スイッチング・フル・ブリッジ・トポロジをベースにしています。フットプリントと部品の高さを最小化するために、平面トランスを使用しています。プリント基板 (PCB) は 6 層であり、上面と底面に部品を実装しています。このユニットは、周囲温度 (TA) が 40℃ (...)
試験報告書: PDF
パッケージ ピン数 ダウンロード
HTSSOP (PWP) 28 オプションの表示
WQFN (RSG) 28 オプションの表示

購入と品質

記載されている情報:
  • RoHS
  • REACH
  • デバイスのマーキング
  • リード端子の仕上げ / ボールの原材料
  • MSL 定格 / ピーク リフロー
  • MTBF/FIT 推定値
  • 材質成分
  • 認定試験結果
  • 継続的な信頼性モニタ試験結果
記載されている情報:
  • ファブの拠点
  • 組み立てを実施した拠点

推奨製品には、この TI 製品に関連するパラメータ、評価基板、またはリファレンス デザインが存在する可能性があります。

サポートとトレーニング

TI E2E™ フォーラムでは、TI のエンジニアからの技術サポートを提供

コンテンツは、TI 投稿者やコミュニティ投稿者によって「現状のまま」提供されるもので、TI による仕様の追加を意図するものではありません。使用条件をご確認ください。

TI 製品の品質、パッケージ、ご注文に関するお問い合わせは、TI サポートをご覧ください。​​​​​​​​​​​​​​

ビデオ