TPS65101
フル統合型の正のチャージ ポンプと 3.3V LDO コントローラと最小 1.6A の電流増幅制限機能と VCOM (電圧補償機能) 搭載、4 チャネル LCD バイアス
TPS65101
- 2.7-V to 5.8-V Input Voltage Range
- 1.6-MHz Fixed Switching Frequency
- 3 Independent Adjustable Outputs
- Boost Converter Output Voltage VO1 of up to 15 V With < 1% Output Voltage Accuracy
- Negative Regulated Charge Pump VO2
- Positive Charge Pump VO3
- Integrated VCOM Buffer
- Virtual Synchronous Converter Technology in Boost Converter
- Auxiliary 3.3-V Linear Regulator Controller
- Internal Soft Start
- Internal Power-On Sequencing
- Fault Detection of all Outputs (TPS65100/05)
- No Fault Detection (TPS65101)
- Thermal Shutdown
- Available in TSSOP-24 and VQFN-24 PowerPAD™ Packages
The TPS6510x series offers a compact and small power supply solution that provides all three voltages required by thin film transistor (TFT) LCD displays. The auxiliary linear regulator controller can be used to generate a 3.3-V logic power rail for systems powered by a 5-V supply rail only.
The main output VO1, is a 1.6-MHz, fixed-frequency PWM boost converter providing the source drive voltage for the LCD display. The device is available in two versions with different internal switch current limits to allow the use of a smaller external inductor when lower output power is required. The TPS65100/01 has a typical switch current limit of 2.3 A, and the TPS65105 has a typical switch current limit of 1.37 A. A fully integrated adjustable charge pump doubler/tripler provides the positive LCD gate drive voltage. An externally adjustable negative charge pump provides the negative gate drive voltage. Due to the high 1.6-MHz switching frequency of the charge pumps, inexpensive and small 220-nF capacitors can be used.
The TPS6510x series has an integrated VCOM buffer to power the LCD backplane. For LCD panels powered by 5 V only, the TPS6510x series has a linear regulator controller using an external transistor to provide a regulated 3.3-V output for the digital circuits. For maximum safety, the TPS65100/05 goes into shutdown as soon as one of the outputs is out of regulation. The device can be enabled again by toggling the input or the enable (EN) pin to GND. The TPS65101 does not enter shutdown when one of the outputs is below its power good threshold.
技術資料
種類 | タイトル | 最新の英語版をダウンロード | 日付 | |||
---|---|---|---|---|---|---|
* | データシート | TPS6510x Triple Output LCD Supply With Linear Regulator and VCOM Buffer データシート (Rev. D) | PDF | HTML | 2016年 8月 31日 | ||
アプリケーション・ノート | 昇圧コンバータの電力段に関する基本的な計算 (Rev. D 翻訳版) | PDF | HTML | 英語版 (Rev.D) | PDF | HTML | 2022年 12月 1日 | |
アプリケーション・ノート | Basic Calculation of a Boost Converter's Power Stage... (Rev. D) | PDF | HTML | 2022年 11月 21日 | |||
アプリケーション・ノート | Understanding Undervoltage Lockout in Power Devices (Rev. A) | 2018年 9月 19日 | ||||
アプリケーション・ノート | Basic calculation of an inverting buck-boost power stage (Rev. A) | 2017年 8月 28日 | ||||
アプリケーション・ノート | How to Estimate the Output Voltage Range of the Charge Pumps in the TPS6510x | 2017年 8月 8日 | ||||
アプリケーション・ノート | Load Disconnect for the TPS6510x (Rev. A) | 2017年 2月 8日 | ||||
アプリケーション・ノート | How to Compensate the TPS6510x and the TPS6514x | 2016年 8月 30日 | ||||
アプリケーション・ノート | Generation of a VCOM buffer input using PWM signal | 2015年 12月 21日 | ||||
アプリケーション・ノート | Minimizing Ringing at the Switch Node of a Boost Converter | 2006年 9月 15日 |
設計と開発
その他のアイテムや必要なリソースを参照するには、以下のタイトルをクリックして詳細ページをご覧ください。
PSPICE-FOR-TI — TI Design / シミュレーション・ツール向け PSpice®
設計とシミュレーション向けの環境である PSpice for TI (...)
パッケージ | ピン数 | ダウンロード |
---|---|---|
HTSSOP (PWP) | 24 | オプションの表示 |
VQFN (RGE) | 24 | オプションの表示 |
購入と品質
- RoHS
- REACH
- デバイスのマーキング
- リード端子の仕上げ / ボールの原材料
- MSL 定格 / ピーク リフロー
- MTBF/FIT 推定値
- 材質成分
- 認定試験結果
- 継続的な信頼性モニタ試験結果
- ファブの拠点
- 組み立てを実施した拠点
推奨製品には、この TI 製品に関連するパラメータ、評価基板、またはリファレンス デザインが存在する可能性があります。