ホーム パワー・マネージメント AC/DC と絶縁型 DC/DC の各スイッチング・レギュレータ 力率改善 (PFC) コントローラ

UCC28063A

アクティブ

可聴ノイズ耐性と入力サージ・ノイズ耐性改善済み、Natural Interleaving 臨界モード PFC コントローラ

この製品には新バージョンがあります。

open-in-new 代替品と比較
比較対象デバイスと同等の機能で、ピン配置が異なる製品
UCC28065 アクティブ 高周波スイッチング対応、Natural Interleaving™ 遷移モード PFC コントローラ The UCC28065 is a high-frequency PFC which can reduce the inductor volume by up to 50%

製品詳細

Topology Boost Control mode TM Switching frequency (max) (kHz) 500 UVLO thresholds on/off (V) 12.6/10.4 Vin (max) (V) 21 Features > 750 W applications, Enable, Interleaved, Overvoltage protection, Peak current mode, Transition Control Mode Rating Catalog Operating temperature range (°C) -40 to 125 Duty cycle (max) (%) 99
Topology Boost Control mode TM Switching frequency (max) (kHz) 500 UVLO thresholds on/off (V) 12.6/10.4 Vin (max) (V) 21 Features > 750 W applications, Enable, Interleaved, Overvoltage protection, Peak current mode, Transition Control Mode Rating Catalog Operating temperature range (°C) -40 to 125 Duty cycle (max) (%) 99
SOIC (D) 16 59.4 mm² 9.9 x 6
  • Input Filter and Output Capacitor Ripple-Current Cancellation
    • Reduced Current Ripple for Higher System Reliability and Smaller Bulk Capacitor
    • Reduced EMI Filter Size
  • Phase Management Capability
  • Fail-Safe OVP with Dual Paths Prevents Output Overvoltage Conditions by Voltage-Sensing Failures
  • Sensorless Current-Shaping Simplifies Board Layout and Improves Efficiency
  • Advanced Audible Noise Performance
  • Non-linear Error-Amplifier Gain
  • Soft Recovery on Overvoltage
  • Integrated Brownout and Dropout Handling
  • Reduced Bias Currents
  • Improved Efficiency and Design Flexibility Over Traditional Single-Phase Continuous Conduction Mode (CCM)
  • Inrush-Safe Current Limiting:
    • Prevents MOSFET Conduction During Inrush
    • Eliminates reverse Recovery Events in Output rectifiers
  • Enables Use of Low-Cost Diodes Without Extensive Snubber Circuitry
  • Improved Light-Load Efficiency
  • Fast, Smooth Transient Response
  • Expanded System-Level Protections
  • 1-A Source/1.8-A Sink Gate Drivers
  • –40°C to 125°C Operating Temperature Range in a 16-Lead SOIC Package
  • Input Filter and Output Capacitor Ripple-Current Cancellation
    • Reduced Current Ripple for Higher System Reliability and Smaller Bulk Capacitor
    • Reduced EMI Filter Size
  • Phase Management Capability
  • Fail-Safe OVP with Dual Paths Prevents Output Overvoltage Conditions by Voltage-Sensing Failures
  • Sensorless Current-Shaping Simplifies Board Layout and Improves Efficiency
  • Advanced Audible Noise Performance
  • Non-linear Error-Amplifier Gain
  • Soft Recovery on Overvoltage
  • Integrated Brownout and Dropout Handling
  • Reduced Bias Currents
  • Improved Efficiency and Design Flexibility Over Traditional Single-Phase Continuous Conduction Mode (CCM)
  • Inrush-Safe Current Limiting:
    • Prevents MOSFET Conduction During Inrush
    • Eliminates reverse Recovery Events in Output rectifiers
  • Enables Use of Low-Cost Diodes Without Extensive Snubber Circuitry
  • Improved Light-Load Efficiency
  • Fast, Smooth Transient Response
  • Expanded System-Level Protections
  • 1-A Source/1.8-A Sink Gate Drivers
  • –40°C to 125°C Operating Temperature Range in a 16-Lead SOIC Package

This part is identical to UCC28063 with the exception that the TSET pin Open/ Short Fault Detect and the CS pin Open Fault Detect features are removed. Removal of these Fault Detect features provides a higher degree of noise immunity to provide increased "ride-through" for applications where significant voltage noise could be coupled onto the TSET or CS pins during conditions of fast transient, surge or impulse noise on the AC Supply.

Optimized for consumer applications concerned with audible noise elimination, this solution extends the advantages of transition mode – high efficiency with low-cost components – to higher power ratings than previously possible. By utilizing a Natural Interleaving technique, both channels operate as masters (that is, there is no slave channel) synchronized to the same frequency. This approach delivers inherently strong matching, faster responses, and ensures that each channel operates in transition mode.

Expanded system level protections feature input brownout and dropout recovery, output over-voltage, open-loop, overload, soft-start, phase-fail detection, and thermal shutdown. The additional FailSafe over-voltage protection (OVP) feature protects against shorts to an intermediate voltage that, if undetected, could lead to catastrophic device failure. Advanced non-linear gain results in rapid, yet smoother response to line and load transient events. Reduced bias currents improve stand-by power efficiency. Special line-dropout handling avoids significant current disruption and minimizes audible-noise generation.

This part is identical to UCC28063 with the exception that the TSET pin Open/ Short Fault Detect and the CS pin Open Fault Detect features are removed. Removal of these Fault Detect features provides a higher degree of noise immunity to provide increased "ride-through" for applications where significant voltage noise could be coupled onto the TSET or CS pins during conditions of fast transient, surge or impulse noise on the AC Supply.

Optimized for consumer applications concerned with audible noise elimination, this solution extends the advantages of transition mode – high efficiency with low-cost components – to higher power ratings than previously possible. By utilizing a Natural Interleaving technique, both channels operate as masters (that is, there is no slave channel) synchronized to the same frequency. This approach delivers inherently strong matching, faster responses, and ensures that each channel operates in transition mode.

Expanded system level protections feature input brownout and dropout recovery, output over-voltage, open-loop, overload, soft-start, phase-fail detection, and thermal shutdown. The additional FailSafe over-voltage protection (OVP) feature protects against shorts to an intermediate voltage that, if undetected, could lead to catastrophic device failure. Advanced non-linear gain results in rapid, yet smoother response to line and load transient events. Reduced bias currents improve stand-by power efficiency. Special line-dropout handling avoids significant current disruption and minimizes audible-noise generation.

ダウンロード 字幕付きのビデオを表示 ビデオ

技術資料

star =TI が選定したこの製品の主要ドキュメント
結果が見つかりませんでした。検索条件をクリアしてから、再度検索を試してください。
4 をすべて表示
種類 タイトル 最新の英語版をダウンロード 日付
* データシート UCC28063A Natural Interleaving™ Transition-Mode PFC Controller With Improved Audible and Input Surge Noise Immunity データシート (Rev. C) PDF | HTML 2016年 11月 22日
アプリケーション・ノート UCC2806x PCB Layout Guideline for PFC 2019年 4月 29日
セレクション・ガイド 電源 IC セレクション・ガイド 2018 (Rev. R 翻訳版) 英語版 (Rev.R) 2018年 9月 13日
EVM ユーザー ガイド (英語) Using the UCC28063EVM 2011年 6月 7日

設計と開発

その他のアイテムや必要なリソースを参照するには、以下のタイトルをクリックして詳細ページをご覧ください。

評価ボード

UCC28063EVM-723 — 評価基板、UCC28063 用、Natural Interleaving 臨界モード PFC コントローラ

The UCC28063EVM-723 (EVM) is a fully assembled and tested circuit for evaluating the UCC28063 Natural Interleaving™ Transition-Mode PFC Controller. The UCC28063EVM-723 is an off line 300W PFC pre-regulator that runs of a universal line input of 85V to 265V RMS and provides a regulated 390V output. (...)
ユーザー ガイド: PDF
シミュレーション・モデル

UCC28063 PSpice Transient Model

SLUM207.ZIP (74 KB) - PSpice Model
計算ツール

SLUC292 UCC28063 Controller Setup Tool

サポート対象の製品とハードウェア

サポート対象の製品とハードウェア

製品
力率改善 (PFC) コントローラ
UCC28063 可聴ノイズ耐性改善済み、Natural Interleaving 臨界モード PFC コントローラ UCC28063A 可聴ノイズ耐性と入力サージ・ノイズ耐性改善済み、Natural Interleaving 臨界モード PFC コントローラ
ハードウェア開発
評価ボード
UCC28063EVM-723 評価基板、UCC28063 用、Natural Interleaving 臨界モード PFC コントローラ
リファレンス・デザイン

TIDA-01495 — 480W、<17 mm, Thin Profile, 94% Efficiency, Fast Transient Response AC/>AC/DC SMPS (スイッチング電源) のリファレンス

TIDA-01495 は、低プロファイル (高さ 17mm)、94.1% のピーク効率、高い電力密度、ユニバーサル入力、24V DC、480W 出力、コンシューマ向け AC/DC 電源のリファレンス デザインです。この回路は、UCC28063Aをベースとするフロント エンドや、2 相のインターリーブ遷移モード (TM) 力率補正 (PFC) によって構成されており、PFC インダクタのサイズを最小化できるほか、EMI (電磁干渉) フィルタの要件を低減することもできます。HB-LLC 絶縁型 DC/DC 段を制御するのは、ハイブリッド ヒステリシス制御 LLC コントローラである (...)
設計ガイド: PDF
回路図: PDF
リファレンス・デザイン

PMP10116 — 200W ナチュラル・インターリーブ・トランジション・モード PFC フライバック LED ドライバ、リファレンス・デザイン

The PMP10116 reference design uses the UCC28063A transition-mode pfc controller to drive LEDs up to 700mA current from an AC input. This flyback PFC topology provides isolation and uses quasi-resonant mode control. It supports analog dimming on the output side.  Refer to LED Driver Based on (...)
試験報告書: PDF
回路図: PDF
パッケージ ピン数 ダウンロード
SOIC (D) 16 オプションの表示

購入と品質

記載されている情報:
  • RoHS
  • REACH
  • デバイスのマーキング
  • リード端子の仕上げ / ボールの原材料
  • MSL 定格 / ピーク リフロー
  • MTBF/FIT 推定値
  • 材質成分
  • 認定試験結果
  • 継続的な信頼性モニタ試験結果
記載されている情報:
  • ファブの拠点
  • 組み立てを実施した拠点

推奨製品には、この TI 製品に関連するパラメータ、評価基板、またはリファレンス デザインが存在する可能性があります。

サポートとトレーニング

TI E2E™ フォーラムでは、TI のエンジニアからの技術サポートを提供

コンテンツは、TI 投稿者やコミュニティ投稿者によって「現状のまま」提供されるもので、TI による仕様の追加を意図するものではありません。使用条件をご確認ください。

TI 製品の品質、パッケージ、ご注文に関するお問い合わせは、TI サポートをご覧ください。​​​​​​​​​​​​​​

ビデオ