ソリッド・ステート・ドライブ(SSD)

テキサス・インスツルメンツ製ソリッド・ステート・ドライブ(SSD)クライアント・ソリューション

設計上の考慮事項

Solid State Drive (SSD) Clients have started to target the Enterprise Server and Notebook/PC markets and are replacing traditional hard-disk drives. Client SSD solutions target higher read/write performance, increased reliability, and lower power consumption than their mechanical predecessors. Key performance vectors of Client SSDs are: Write Endurance/Performance, Error/Defect Rates, and Data Security. Design challenges include size and heat dissipation reductions.

Power Supply Efficiency and Heat:

Heat and heat tolerance is a key concern in device selection for Client SSD solutions considering that the drives may be used in RAIDs/Notebook PCs which have a significant power dissipation on their own. A typical Client SSD can draw 2-4 amps in typical operation. When size/storage capacity increases, Client SSDs use more power as additional memory is used to run system tasks.

Power supply units with less noise and higher efficiency will increase the longevity of the Client SSD by reducing the internal heat environment. More efficient PMUs can also decrease the number of erroneous rewrites by providing more stable voltage rails for the NAND and FLASH memory cells. It is important to select power solutions that have good efficiency at light/full loads since the drive can spend most of it's time in standby mode. Concurrently, power solutions ramp up and become stable more quickly without exceeding the regulation voltage limitations. This allows the SSD Client solutions to awaken, accept/process data and return to standby in a shorter timeframes.

SSD Client Interfaces:

For Client SSDs, SATA is the common interface. First generation has a maximum transfer rate of 1.5 Gbits/s, while the 2nd and 3rd generation supports between 3gb-6gb/s on average. The interface drivers are usually designed into core chips set within the drive. Considerations may need to be made for ESD protection or transient suppression on all connections. M.2 (or NGFF-Next Generation Form Factor) is becoming increasingly popular in applications needed to take up less space, and can support both SATA and PCIe interfaces at a maximum transfer rate of 6 gb/s.

ブログ

サポートとトレーニング

技術的な質問と回答を豊富に掲載している TI の包括的なオンライン・ナレッジ・ベースは 24 時間 365 日ご利用になれます。

TI のエキスパートによる回答の検索

コミュニティ内のコンテンツは、個別の TI 投稿者やコミュニティ投稿者によって「現状のまま」提供されるもので、TI による仕様の追加を意図するものではありません。
使用条件をご確認ください

TI 製品の品質、パッケージ、ご注文に関するお問い合わせは、TI のサポート・ページをご覧ください