JAJSH94 April 2019 BQ79606A-Q1
PRODUCTION DATA.
OTP_CUST2_STAT1 Register Address: 0x280 | |||||||
B7 | B6 | B5 | B4 | B3 | B2 | B1 | B0 |
RSVD | LOADED | LOADWRN | LOADERR | FMTERR | PROGOK | RETRY | FREE |
0 | 0 | 0 | 0 | 0 | 0 | 0 | 1 |
R | R | R | R | R | R | R | R |
RSVD | Reserved | ||||||
LOADED | Indicates OTP page 2 has been selected for loading into the related registers. See LOADERR and LOADWRN for error and warning status.
0: Not selected for loading 1: Page 2 selected for loading |
||||||
LOADWRN | Indicates OTP page 2 was loaded but with one or more SEC warnings. (See the "Error Check and Correct (ECC) OTP" section for details)
0: No warning, or no load attempted 1: Warning |
||||||
LOADERR | Indicates an error while attempting to load OTP page 2.
0: No error, or no load was attempted. 1: Error |
||||||
FMTERR | Indicates a formatting error in OTP page 2. For example, OTP_CUST2_STAT2[TRY2] is '1' but both OTP_CUST2_STAT2[TRY1] and OTP_CUST1_STAT2[UV1OK] are set 1. Do not program if a FMTERR is set.
0: No error 1: Error |
||||||
PROGOK | Indicates the validty for loading for OTP page 2. A valid page indicates that successful programming occurred. (See Programming NVM section for details)
0: NOT valid 1: Valid |
||||||
RETRY | Indicates if OTP page 2 is available for a programming retry. Do not program if a FMTERR is set. (See Programming NVM section for details). This bit is useful for prototype only. If this bit is flipped during production, the device needs to be taken out of service.
0: NOT available for programming retry 1: Available for programming retry |
||||||
FREE | Indicates the programming availability status of OTP page 2. Do not program if a FMTERR is set. (See Programming NVM section for details)
0: NOT available 1: Available |