JAJSHZ0A April 2013 – September 2019 TMP108
PRODUCTION DATA.
To communicate with the TMP108, the master must first communicate with slave devices using a slave address byte. The slave address byte consists of seven address bits, and a direction bit indicating the intent of executing either a read or write operation. The TMP108 features an address pin that allows up to four devices to be addressed on a single bus. The TMP108 latches the status of the address pin at the start of a communication. Table 2 describes the pin logic levels and the corresponding address values. Other values for the fixed address bits are available by request.
DEVICE TWO-WIRE ADDRESS | A0 PIN CONNECTION | |
---|---|---|
TMP108 | ||
1001000 | Ground | |
1001001 | V+ | |
1001010 | SDA | |
1001011 | SCL |