JAJSIO3A February 2020 – September 2020 TPS546B24A
|Write Transaction:||Write Word|
|Read Transaction:||Read Word|
|Format:||Unsigned Binary (2 bytes)|
MFR_SPECIFIC_29 is used to configure miscellaneous settings.
|LEGEND: R/W = Read/Write; R = Read only|
0b: PEC Optional. Transactions received without PEC byte will be processed.
1b: PEC Required. Transactions received without PEC byte will be rejected as COMS_FAIL in Section 7.6.60.
0b: VOUT_COMMAND will be unchanged following a shutdown.
1b: VOUT_COMMAND will be changed to VBOOT on a Control or OPERATION shutdown.
0b: VOUT_COMMAND will be unchanged following a Fault Restart.
1b: VOUT_COMMAND will be changed to VBOOT on Restart from a Fault when Fault Retry is set to Retry after Fault.
Sets the function of the PGD/RESET_B pin.
0b: PGD/RESET_B functions as PGOOD and internal pullup is disabled.
1b: PGD/RESET_B functions as RESET# and internal pullup is set by bit 3 PULLUP#.
Reserved. Must be 000000000b
Sets the pullup of the PGD/RESET_B pin when RESET# = 1b.
0b: Internal pullup of PGD/RESET_B pin enabled when RESET# = 1b.
1b: Internal pullup of PGD/RESET_B pin disabled when RESET# = 1b.
0b: Fault Counter counts down one cycle on PWM cycle without fault
1b: Fault Counter resets counter to 0 on PWM cycle without fault
ADC Resolution Control
00b: Set ADC Resolution to 12-bit
01b: Set ADC Resolution to 10-bit
10b: Set ADC Resolution to 8-bit
11b: Set ADC Resolution to 6-bit