狭帯域システム向け、超高性能 Sub-1GHz ワイヤレス・トランシーバ
製品の詳細
パラメータ
パッケージ|ピン|サイズ
特長
- High-Performance, Single-Chip Transceiver
- Adjacent Channel Selectivity: 67 dB at
6.25-kHz Offset - Blocking Performance: 104 dB at 10 MHz
- Excellent Receiver Sensitivity
- –129 dBm at 300 bps
- –123 dBm at 1.2 kbps
- –110 dBm at 50 kbps
- Very Low Phase Noise: –115 dBc/Hz at
10-kHz Offset
- Adjacent Channel Selectivity: 67 dB at
- Suitable for Systems Targeting ETSI
Category 1 - Separate 128-Byte RX and TX FIFOs
- Support for Seamless Integration With the CC1190 Device for Increased Range Giving up to 3-dB Improvement in Sensitivity and up to +27-dBm Output Power
- High Spectral Efficiency (9.6 kbps in 12.5-kHz Channel in Compliance With FCC Narrowbanding Mandate)
- Power Supply
- Wide Supply Voltage Range (2.0 V to 3.6 V)
- Low Current Consumption:
- RX: 2 mA in RX Sniff Mode
- RX: 17 mA Peak Current in Low-Power Mode
- RX: 26 mA Peak Current in High-Performance Mode
- TX: 47 mA at +14 dBm
- Power Down: 0.12 μA (0.5 μA With Enhanced Wake-On-Radio (eWOR) Timer Running)
- Programmable Output Power up to +16 dBm With 0.4-dB Step Size
- Automatic Output Power Ramping
- Configurable Data Rates: 0 to 200 kbps
- Supported Modulation Formats: 2-FSK,
2-GFSK, 4-FSK, 4-GFSK, MSK, OOK - WaveMatch: Advanced Digital Signal Processing for Improved Sync Detect Performance
- RoHS-Compliant 5-mm x 5-mm No-Lead QFN
32-Pin Package (RHB) - Regulations – Suitable for Systems Targeting Compliance With
- Europe: ETSI EN 300 220 Category 1, ETSI EN 54-25, ETSI EN 300 113, and EN 301 166
- US: FCC CFR47 Part 15, 24, 90, 101
- Japan: ARIB RCR STD-T30, T-67, T-108
- Peripherals and Support Functions
- eWOR Functionality for Automatic Low-Power Receive Polling
- Includes Functions for Antenna Diversity Support
- Support for Retransmissions
- Support for Auto-Acknowledge of Received Packets
- TCXO Support and Control, also in Power Modes
- Automatic Clear Channel Assessment (CCA) for Listen-Before-Talk (LBT) Systems
- Built-in Coding Gain Support for Increased Range and Robustness
- Digital RSSI Measurement
- Temperature Sensor
概要
The CC1125 device is a fully integrated single-chip radio transceiver designed for high performance at very low-power and low-voltage operation in cost-effective wireless systems. All filters are integrated, thus removing the need for costly external SAW and IF filters. The device is mainly intended for the ISM (Industrial, Scientific and Medical) and SRD (Short Range Device) frequency bands at 164–192 MHz, 274–320 MHz, 410–480 MHz, and 820–960 MHz.
The CC1125 device provides extensive hardware support for packet handling, data buffering, burst transmissions, clear channel assessment, link quality indication, and Wake-On-Radio. The main operating parameters of the CC1125 device can be controlled through an SPI interface. In a typical system, the CC1125 device will be used with a microcontroller and only a few external passive components.
技術資料
設計と開発
追加の事項や他のリソースを参照するには、以下のタイトルをクリックすると、詳細ページを表示できます。ハードウェア開発
概要
特長
- Can be used with both LaunchPad and SmartRF Studio applications
- Same design can be used for both 868 MHz and 915 MHz frequecy bands with minor BOM changes
- Same design can be used with CC112x devices and CC12xx devices with minor BOM changes
- Integrated PCB trace Antenna
概要
SmartRF Transceiver 評価ボード(TrxEB)は、評価、性能テスト、ソフトウェア開発のため、TI のローパワー RF トランシーバと組み合わせて使用します。
以下のトランシーバ評価モジュールがサポートされています。
- CC1101EM*
- CC11xLEM*
- CC112xEM*
- CC1175EM*
- CC1200EM*
- CC2500EM
- CC2520EM
(*) すべての周波数派生版、および CC1190 との組み合わせもサポートされています
評価モジュールは、TI ストアで別売りの EMK(評価モジュール・キット)の形で入手できます
SmartRF TrxEB を使用して実行できる作業
- MSP430F5438A マイコンでの無線プロトコルの開発。関連するトランシーバの Web ページに掲載されているコード・サンプルの参照。
- SmartRF Studio を使用したトランシーバの性能評価。
- TrxEB+EM を使用して得られた結果と、独自ハードウェアから得られた結果の比較。
- 独自ボードの無線を TrxEB に接続し、既知の正常に動作するソフトウェアを使用して独自の RF 設計をテスト。その後、SmartRF Studio を使用して無線の実験。
- 独自ボード上のマイコンを TrxEB に実装されているブレークアウト・ピン 経由でトランシーバ EM に接続し、既知の正常に動作する RF ハードウェアを使用して独自ソフトウェアをテスト。
ボードの最新情報については、SmartRF TrxEB ユーザーズ・ガイドを参照してください。このガイドでは、ドライバのインストール方法、ボードに実装されているペリフェラルの詳細、トランシーバ評価モジュールとのインターフェイス確立方法について説明しています。
特長
- MSP430F5438A マイコン
- 64 x 128 ピクセルのシリアル LCD
- 4 個の汎用 LED
- 5 個の押しボタン
- 256KB のシリアル Flash
- 3 軸デジタル加速度計
- 周辺光センサ
- 電流測定用のジャンパ
- ブレークアウト・ピン
- フルスピード USB 2.0 インターフェイス
- SmartRF Studio のサポート
概要
概要
The CC Debugger is a small programmer and debugger for the TI Low Power RF System-on-Chips. It can be used together with IAR Embedded Workbench for 8051 (version 7.51A or later) for debugging and SmartRF Flash Programmer for flash programming. The CC Debugger can also be used for controlling (...)
特長
Contents in the box:
- CC Debugger
- Mini USB cable
- 10-pin flat cable with 2x5 2.54mm connector
- 10-pin flat cable with 2x5 1.27mm connector
- Converter board 2.54mm-1.27mm connector
- Documentation
CC-Debugger can be used to program and debug the following 8051-based system-on-chips from Texas Instruments:
- CC1110 (...)
概要
The CC1120 development kit provides a complete hardware performance testing and software development platform for TI's Sub-1 GHz Performance Line devices. The development kit comes with a pre-programmed packet error rate test. RF range and robustness can be tested with different RF settings, and (...)
特長
- 2 x SmartRF Transceiver EB (TrxEB)
- 2 x CC1120EM 868/915 MHz
- 2 x Pulse Antennas
- 1 x MSP430 Debug Probe (FET)
- 2 x Micro USB Cables
- 1 x Standard USB Cable
- 1 x 14-pin Flat Cable
- 4 x 1.5 Volt AA Batteries
- Documentation
概要
The CC1125 development kit provides a complete hardware performance testing and software development platform for TI's Sub-1 GHz Performance Line devices and CC1125 specifically. The development kit comes with a pre-programmed packet error rate test. RF range and robustness can be tested with (...)
特長
- 2 x SmartRF Transceiver EB (TrxEB)
- 2 x CC1125EM 869 MHz
- 2 x Pulse Antennas
- 1 x MSP430 Debug Probe (FET)
- 2 x Micro USB Cables
- 1 x Standard USB Cable
- 1 x 14-pin Flat Cable
- 4 x 1.5 Volt AA Batteries
- Documentation
概要
This BoosterPack kit contains one "EM Adapter BoosterPack". The purpose of the EM adapter board is to provide an-easy-to-use bridge between any of the TI MCU LaunchPads and the wide variety of TI RF evaluation modules (EM), for instance the CCxxxx Low-Power RF evaluation modules. No specific (...)
特長
- Evaluation Module (EM) connectors supporting all EMs from Texas Instruments
- Dual-row LaunchPad (LP) connectors, allowing stacking of XL BoosterPacks
- USB power supply to support assemblies drawing more current than the LaunchPad is able to source alone
- Buck/boost voltage regulator, allowing any power (...)
ソフトウェア開発
設計ツールとシミュレーション
特長
- Based on our TI wireless technology supporting Wi-Fi®, Bluetooth®, Zigbee®, Sub-1 GHz, Sigfox, 2.4 GHz ,multi-band connectivity and more
- Integrates clocks, SPI flash and passive components
- Years of successful collaboration
- Includes hardware customization, software integration and cloud services
- Links to (...)
SmartRF Packet Sniffer 2
SmartRF Packet Sniffer 2 includes software and firmware to capture and display over-the-air packets. The capture device is connected to the PC via USB. SmartRF Packet Sniffer 2 supports the CC13xx and CC26xx family of devices as capture device and uses Wireshark for packet (...)
特長
- Sub-1GHz デバイスと 2.4GHz デバイス向けの距離概算スプレッドシート
- 距離デバッグ・チェックリスト
特長
- リンク・テスト:ノード間でパケットを送受信します。
- アンテナ / 放射線試験:連続波の TX と RX 状態で無線を設定します。
- 全製品に対するレジスタの推奨 / 代表値。
- 個別の RF レジスタの読み取りと書き込みを行います。
- 無線制御のために個別のコマンドを実行します。
- 各レジスタまたはコマンドのビット・フィールドに関する詳細情報。
- ファイルからデバイス構成データの保存と読み込みを行います。
- レジスタの設定値とコマンド引数を、ユーザー定義可能なフォーマットにエクスポートします。
- 無線構成コードをエクスポートします(CC13xx、CC26xx)。
- カスタム GPIO 構成を可能にします(CC13xx、CC26xx)。
- デバッグ・プローブまたは評価ボードを通じて、USB 経由で複数の評価ボードと通信します。
- 単一のコンピュータで最大 32 の評価ボードをサポートします。
互換性に関する問題
SmartRF Studio 6 は、Microsoft® Windows 98、Windows 2000、Windows XP (32 ビット)、Windows Vista (32 ビット)、Windows 7 (32 ビット) の各環境で動作します。
SmartRF Studio 7 は、32 ビット版と 64 ビット版の Microsoft® Windows 7、8、10 で動作します。
インストール手順:
- 該当 ZIP ファイルをハード・ディスクにダウンロードします。
- そのファイルを解凍します。
- readme.txt ファイルを読み、このリリースに関する情報を参照します。
- 手順に従ってセットアップ・ファイルを実行します。
リファレンス・デザイン
設計ファイル
-
download Data Collector for wM-Bus & DSSS-Coded Long Range BOM (from CC1125EM-868-915-RD).pdf (52KB) -
download Data Collector for wM-Bus & DSSS-Coded Assembly Files (from CC1125EM-868-915-RD).zip (39KB) -
download Data Collector for wM-Bus & DSSS-Coded Long Range PCB (from CC1125EM-868-915-RD).pdf (237KB) -
download Data Collector for wM-Bus & DSSS-Coded CAD Files (from CC1125EM-868-915-RD).zip (343KB) -
download Data Collector for wM-Bus & DSSS-Coded Gerber (from CC1125EM-868-915-RD).zip (103KB)
設計ファイル
CAD/CAE シンボル
パッケージ | ピン数 | ダウンロード |
---|---|---|
VQFN (RHB) | 32 | オプションの表示 |
購入と品質
- RoHS
- REACH
- デバイスのマーキング
- リード端子の仕上げ / ボールの原材料
- MSL rating/ リフローピーク温度
- MTBF/FIT の推定値
- 原材料組成
- 認定試験結果
- 継続的な信頼性モニタ試験結果
おすすめの製品には、この TI 製品に関連するパラメータ、評価モジュール、またはリファレンス・デザインが含まれている場合があります。